Drone Accessories New F4 Pro V2 V3.5 V3S Flight Control Built-in for OSD/BEC for INAV Betaflight for APEX FPV Racing Drone DIY Quadcopter for BN220 GPS Replaceable

New F4 Pro V2 V3.5 V3S Flight Control Built-in for OSD / BEC for INAV Betaflight for APEX FPV Racing Drone DIY Quadcopter for BN220 GPSSPECIFICATIONS:For MicroSD BlackboxFor Baro (For BMP280)( default is closed,need to open in configuration,if not know how to open,contact with us)For F4 Processor (F405)5v3a SBECBuilt-in Current SensorOn-Board Video Filter (only can supply 5V to For VTX and Camera)USING for PPMIf you have trouble geting the For FC to recognise your For PPM receiver, here is what you need to do. You need to enable For RX_serial in the For GUI and turn For UART3 on. Save and reboot the flight controller. Then re-selecting For RX_PPM again on the For GUY and the For FC now communicates with your For PPM receiver1PCs x For Omnibus F4 V2 PRO Flight Controller w/ Pin and Wire

• This is the all new For omnibus F4 Pro, based on the design of the popular For omnibus F3 pro. However this main advantage of this board is that is uses the more powerful STM F4 processor for even faster loop times. It has all the other things you love from the For Omnibus F3 pro including an For OSD module, For SD card reader, low noise For IC268G IMU connected via For SPI, a current and voltage sensor etc..
• The For V2 pro version now includes a built in BEC , so you can power this board directly from your flight battery (up to 4s)
• For SPI Gyro IC268G
• On-Board For OSD (controllered by For Betaflight, For FC over For SPI bus)
• Tested in good condition,100% working!